Motion Test Stream Generator
Instructions

COnfiguration procedure:

(0) Configure BOARD 0 with motion.bit
(1) Configure BOARD 1 with your design
(2) Connect an RCA cable from VIDEO OUT of BOARD 0 to VIDEO IN of BOARD 1
    (not vice versa)
(4) Enjoy

The settings for motion.bit are:

SW9[1]		:	global enable
SW9[6:5]	:	output select:

			0 = 8x8 block moves horizontally
			1 = 8x8 block moves vertically
			2 = variable angle spinning beams

Sw10		:	beam angle

There are a few RCA cables around in the lab.
Only proceed when ready to test your final design.
If unsure of the above procedure, please ask a TA for assistance.