| Allegro CL version 6.2 Moderately revised from 6.1 | |||||||||
Arguments: (self rpc-port) (m rpc-message) &rest modifiers
This method is used with the message handle returned by rpc-invoke to query the state of a remote call. The value is a keyword that describes the state of the message. The possible keywords are:
:rms-begin-invoke: a call has been initiated.
:rms-arguments: the arguments to the call are being transmitted.
:rms-invoke-sent: the entire call has been transmitted.
:rms-invoke-confirmed: the call has been
acknowledged by the remote host. This state appears only if the
confirm argument of the port is non-nil.
:rms-receiving-results: the results are arriving.
:rms-result-received: all the results have arrived.
This state appears only if the
confirm argument of the port is non-nil.
:rms-done: the results have been confirmed and the
call has completed successfully.
:rms-error-received: the call is completed, but the
remote host is transmitting error information. This state appears only if the
confirm argument of the port is non-nil.
:rms-error: the call is completed, but the remote
host signaled an error.
:rms-throw: the call was cut short by a throw in
the remote host.
See also rpc.htm for general information on the Remote Procedure Call utility in Allegro CL.
Copyright (c) 1998-2002, Franz Inc. Oakland, CA., USA. All rights reserved.
Documentation for Allegro CL version 6.2. This page has had moderate revisions compared to the 6.1 page.
Created 2002.2.26.
| Allegro CL version 6.2 Moderately revised from 6.1 | |||||||||